Chandler, Arizona
Seamless gutter installation in Chandler.
Chandler is mostly tile roofs on homes built between the late 1980s and the 2000s — houses that were handed over without gutters and have been shedding water off the edge ever since.
Newer homes, and one very good reason to size properly
Chandler grew through the late 1980s, the 1990s and the 2000s, which puts it firmly in the tile-roof era. Tile delivers water to the roof edge faster and more concentrated than shingle does, and a lot of Chandler homes are two-storey with substantial roof areas draining toward relatively few points. That combination is the clearest case there is for six-inch rather than five-inch.
These are also almost all builder homes that shipped without gutters. Most of our Chandler work is first-time installation on a house that is fifteen or twenty years old, not replacement — which surprises people who assume gutters are something that wears out rather than something they never had.
Chandler is a reminder that sizing for the average is the wrong instinct here. In 2016 the area recorded a macroburst with winds measured at 116 mph. Monsoon in the East Valley is not a gentle event, and a system sized for a typical rainfall figure rather than a burst is a system that overflows exactly when you need it.
Most of the newer subdivisions are HOA-governed with exterior appearance rules, so colour matching to fascia or trim is usually part of the conversation. And Chandler has a substantial 55-plus population in the Sun Lakes area and similar communities — if you are done getting on ladders, say so, because it changes what we recommend.
What we install in Chandler
- Seamless gutter installation — formed on site, hand-cut corners
- Micro-mesh gutter guards
- Repair — sagging runs, leaking corners, storm overflow
- Drainage — drain lines, French drains, scuppers, rain tanks
- Commercial work under our CR-45 licence
Why homeowners here call us
Formed on site, not in a warehouse
We run our own roll-forming machine at your house. Your gutters are made to your roofline in one continuous piece — no shop, no shipping, no splicing lengths together to make them fit.
Corners cut by hand
We hand-cut and strip-miter every corner. It takes longer than snapping a pre-made box miter into place, and it is the difference between a corner that reads as a clean line and one that reads as a joint.
Real hardware
Proper downspout straps, not recycled scrap. The parts nobody looks at are the parts that fail first.
Our crew, not a sub
Gutter work is done by our own employees. The only thing we sub out is fascia and wood-rot carpentry, and we tell you before we do it.
Chandler questions
My Chandler house is from the nineties. Why has it never had gutters?
Do I need six-inch?
My HOA has appearance rules.
Do you work in Sun Lakes and the other 55-plus communities?
Serving Chandler and the surrounding Valley.
Free estimate, honest answer, no pressure.